89 civic si - electrical issues

[rbwdriven]

Ok this one is a little mind boggling.

I've been recently putting a hatch back together that I purchased a while ago. Well when the person pulled the main harness to paint the engine back some wires were hacked up. I soldered said wires.

Now x many months later, I have this issue.

No keys near ignition. Turn the headlight switch on to running lights. One the driver side I get running lights, on the passenger side I get running light and turn signal light. On the dash I get the temp gauge pegged, fuel gauge pegged and also both turn signal lights on.

with headlight switch in same position and key on I get the same as above but no temp or fuel pegged.

Got any clues?

I can not turn the hazzard on or even the turn signals on.

I'm too the point of ripping the main harness out and finding a good one that has not been hacked up.

I'd like to get his issue resolved then I can go on to other issues on why it is not starting but I want to get one thing done at a time.

Thanks
Richard

[bigdare23]

I think the best way to fix it would be replacing it. Or atleast pull out the harness and check it from one side to the other.

[sakasaku]

i have a whole oBD0 harnass if u need it or just a part what ever!

[rbwdriven]

is it for a 89 si?

i know the connectors are different to connect the engine harness.

let me know. pm me with price.

[rbwdriven]

Figured out what went wrong.

Combination of things.

Fuses blown, lamps blown and a cut in the headlight harness that I did not see when I was soldering the complete harness.

No issues now.

Fired car up yesterday. I made enough noise with blowing the carbon out of the exhaust that I had 4 of my neighbors over.

Engine has not been run in approximately 6 years as far as me and a buddy can remember.

[bigdare23]

It's good to see you back on the road homie!!

[rbwdriven]

yeah now I have two Ef's that are on the road.

I'm now at 95% of finishing this one and I can change focus and do my other car.