427ci SBF Race Motor 600+hp NA 1000+hp on Nitrous

[Big Baller]

427ci SBF Race Motor 600+hp NA 1000+hp on Nitrous

--------------------------------------------------------------------------------

This Motor has never even been fired

World Products Block
Eagle Crank
Eagel Rods
Mahle Pistons
Total Seal Rings
Clevite Bearings
13.5 to 1 compression
Ported AFR 225 Heads
Upgraded Valves and Valve Springs
Jesel Solid Roller Lifter
Jesel Shaft Mount Rockers
Danny Bee Belt Drive
Bennett Nitrous Cam
Trick Flow Box intake
Accufab 90mm Throttle Body
MSD distributer
ATI Dampner
Fuel Rails
42lb injectors
Water Neck
Tilton Starter
MSD Plug Wires
Trick Flow Nitrous Plate



Motor is setup for Fuel Injection I have a FAST setup that is available with it.
I've got over 12,000 invested in just the motor. Ill listen to any reasonable offer. I might even consider a trade for a street car.

Also available is a Viper T-56 with Mcleod bellhousing adapter and a Mcleod Twin Disk Clutch as well as a set of Kooks Headers. I also have a MSD 7AL2 and a MSD coil that can go with it.

Motor is supposed to make in the 600hp range with no spray and was setup to make over 1000whp.

These are all brand new parts this motor has never been fired. I would love to keep it but I need the money to start a new business venture and building another car just because I have the motor is not a good idea.

$10,000 obo
Matt

[MachNU]

WTF did you pull this out of or what the **** where you planning on putting it in! thats one hell of a set-up!

[Big Baller]

WTF did you pull this out of or what the **** where you planning on putting it in! thats one hell of a set-up!

It was going in my 2000 Ford Mustang, but I sold it. I was going to keep it and put it in a Cobra kit car but I don't have the time or money to build one like I would want to right now.

[Big Baller]

bumpage

[J-ROCK]

this bit would be bad in a 90 to 93 coupe mustang! gl with the sale man

[NevrNufTorq]

bump for an awesome motor!!! :goodjob:

[Big Baller]

Thanks man, with the right setup this motor has got 8s in it no problem.

[Big Baller]

bump for an awesome motor!!! :goodjob:

Thanks Dave

[Init2winit]

What is the compression height on the pistons, and how much ring land do they have? Also, what kind of work has been done to the heads, and who done it? Do the rods have std rod bolts, or the upgraded bolts?

[Nateds16]

is it a 427 cobra jet

[Big Baller]

What is the compression height on the pistons, and how much ring land do they have? Also, what kind of work has been done to the heads, and who done it? Do the rods have std rod bolts, or the upgraded bolts?

Ill have to go find the build sheets as I don't remember the compression height of the pistons.

The heads were raw 225 AFRs that my machine shop sent out to have some CNC work done Ill shoot them a call and ask who it is they use. The rod bolts are upgraded ARPs.