Big Baller
09-01-2008, 12:24 AM
427ci SBF Race Motor 600+hp NA 1000+hp on Nitrous
--------------------------------------------------------------------------------
This Motor has never even been fired
World Products Block
Eagle Crank
Eagel Rods
Mahle Pistons
Total Seal Rings
Clevite Bearings
13.5 to 1 compression
Ported AFR 225 Heads
Upgraded Valves and Valve Springs
Jesel Solid Roller Lifter
Jesel Shaft Mount Rockers
Danny Bee Belt Drive
Bennett Nitrous Cam
Trick Flow Box intake
Accufab 90mm Throttle Body
MSD distributer
ATI Dampner
Fuel Rails
42lb injectors
Water Neck
Tilton Starter
MSD Plug Wires
Trick Flow Nitrous Plate
Motor is setup for Fuel Injection I have a FAST setup that is available with it.
I've got over 12,000 invested in just the motor. Ill listen to any reasonable offer. I might even consider a trade for a street car.
Also available is a Viper T-56 with Mcleod bellhousing adapter and a Mcleod Twin Disk Clutch as well as a set of Kooks Headers. I also have a MSD 7AL2 and a MSD coil that can go with it.
Motor is supposed to make in the 600hp range with no spray and was setup to make over 1000whp.
These are all brand new parts this motor has never been fired. I would love to keep it but I need the money to start a new business venture and building another car just because I have the motor is not a good idea.
$10,000 obo
Matt
--------------------------------------------------------------------------------
This Motor has never even been fired
World Products Block
Eagle Crank
Eagel Rods
Mahle Pistons
Total Seal Rings
Clevite Bearings
13.5 to 1 compression
Ported AFR 225 Heads
Upgraded Valves and Valve Springs
Jesel Solid Roller Lifter
Jesel Shaft Mount Rockers
Danny Bee Belt Drive
Bennett Nitrous Cam
Trick Flow Box intake
Accufab 90mm Throttle Body
MSD distributer
ATI Dampner
Fuel Rails
42lb injectors
Water Neck
Tilton Starter
MSD Plug Wires
Trick Flow Nitrous Plate
Motor is setup for Fuel Injection I have a FAST setup that is available with it.
I've got over 12,000 invested in just the motor. Ill listen to any reasonable offer. I might even consider a trade for a street car.
Also available is a Viper T-56 with Mcleod bellhousing adapter and a Mcleod Twin Disk Clutch as well as a set of Kooks Headers. I also have a MSD 7AL2 and a MSD coil that can go with it.
Motor is supposed to make in the 600hp range with no spray and was setup to make over 1000whp.
These are all brand new parts this motor has never been fired. I would love to keep it but I need the money to start a new business venture and building another car just because I have the motor is not a good idea.
$10,000 obo
Matt