throttlebody spacer

[choabie]

does anyone know if a d series throttlebody spacer will fit on a gsr?

[seanrg1116]

yea it will just run a d throttle body also it has a smaller port so it will give u way more hp:ninja:

[choabie]

yea it will just run a d throttle body also it has a smaller port so it will give u way more hp:ninja:thanks ill see what happens

[Init2winit]

yea it will just run a d throttle body also it has a smaller port so it will give u way more hp:ninja:Only when using a "tornado".

[choabie]

Only when using a "tornado".so i can just use the spacer on my gsr?its different then a single cam tb. how do i pull the bolts out of the intake that go thru the throttle body?

[1SOL2NV]

you dont.. they are the same TB except the GSR TB has a bigger opening than a d series .. i had a gsr tb on my Z6 back in the day and port matched it to the intake mani .. to get the right flow you will have to port match the D series TB to the gsr intake manifold ( lots of dremel tool work) .. and there you go . d series = 52 mm GSR = 57mm <--- someone correct me but i think im close enough for him to get the point:goodjob:

[choabie]

ok thanks. but i had bolts come with my tb and im just wondering how to get the stock bolts out.

[E=MC²]

double nut them. then turn the back one. thats what i did on my civic

[choabie]

im confused on what your tryin to say.

[1SOL2NV]

use the stock bolts .... i know u prolly got some shiny bolts n **** . but use wut works . function >form or jus buy a skunk2 intake manifold and you can use your bolts the TB came with .since the skunk2 intakes dont have the STUD sticking out like a stock manifold does ... u can take that stud out .. but you'll be risking tearing that manifold up ... some come out with ease and some break causing the manifold to be trashed .