PDA

View Full Version : Sub's stopped working



1MP0RTL0V3R
07-01-2008, 01:59 PM
Idk what happen but this morning i was listening 2 music while cleanin my car and out of no were my stereo shuts off and turns back on and then my sub's stop working i check the and everything was still conected and ma amp is getting power any sudgestions on what i should do?

BanginJimmy
07-01-2008, 02:16 PM
have you check fuses? It may be getting power, but not enough to run the amp
check signal, is there any voltage on the input or output side of the amp?

1MP0RTL0V3R
07-01-2008, 03:20 PM
i checked everything all the fuses are fine... and i was running the car while i was cleaning it so the battary wouldn't die because i know i gotta change the battary because it usually doesn't wanna start in the mornings but i am gunna change the battary

BanginJimmy
07-01-2008, 03:54 PM
check your signal, and make sure the amp isnt going into protection because of low voltage, low impedance, or some other issue.

1MP0RTL0V3R
07-01-2008, 05:45 PM
so it mite b cuz of ma battary?

BanginJimmy
07-01-2008, 10:02 PM
what?

patrick4588
07-02-2008, 12:52 AM
check your signal, and make sure the amp isnt going into protection because of low voltage, low impedance, or some other issue.

thats what i was thinking.

1moreaccord
07-02-2008, 10:22 AM
Happened to a system I did once..

The actual speaker went bad.. It was brand new and only 2 hrs after installing

If all the wiring is good try a friends sub or a speaker on your amp and see if it works..

1MP0RTL0V3R
07-02-2008, 11:23 AM
i know that my amp is good and well from what i know my speakers are 2 ive had them 4 a few months now and the've worked fine without a problem because my amp is a kenwood and i got 2 kickers... how do i check if its gone in2 protection mode and if its in that how do i get it off of it?

BanginJimmy
07-02-2008, 11:49 AM
first off use real words and puntuation, your posts would be much easier to read.


1. use a DMM and check the resistance of the subs and see if you fried a coil.
2. use a DMM and check the voltage on the RCA's going into the amp
3. Use a DMM to check the voltage going to your subs

1MP0RTL0V3R
07-06-2008, 10:56 PM
i found out it was ma stereo dat wasnt workin i gotta buy a new 1

patrick4588
07-07-2008, 12:38 AM
i found out it was ma stereo dat wasnt workin i gotta buy a new 1

i found out you fail at life and talk like an ignorant retard :2up:

dabuilding
07-31-2008, 08:28 PM
some ****s tricky like that have u looked at all ur wires like to the subs or the rca cables maybe u unplugged somethin or maybe its not getting enough power that happened to my fav. amp once but i fixed it