Pressure Plate Not going ON!!

[Importdreamer56]

So,I gotten to the point where I have gotten the flywheel on good. But I ran into the problem when I was putting on the new pressure plate. Not all of the pins will line up with the pressure plate. Do i need to get a new lighten flywheel or do i need to do some type of modification. I got the competition clutch stage 4.

The pictures are two of the old one showing how its goes on really easily

The other two pictures show the new pressure plate, however, the three dial pins do not line up with the new pressure plate

i already posted this on rx7club, thought i might get a different response on here

[Spyder]

you have the wrong clutch setup , send it back and get the proper one, when you get it , it will slide on like the other one.

[Importdreamer56]

thats what im thinking also

[Spyder]

either that or you need to spin it around some so it lines up lol.. did you hold the bottom of the pressure plates together to make sure they are the same thing?

[Importdreamer56]

yes, lol i did they are just a little off. I'm thinking they did give me the wrong one.

[1439/2000]

Maybe you got a FC Clutch. Dont they have a different pull set up?

[PSINXS]

you have the wrong clutch setup , send it back and get the proper one, when you get it , it will slide on like the other one.
what he said.

[Importdreamer56]

I got it from Tiger Racing

[redlinenprelude]

its probably for a fc..

[Importdreamer56]

Thats what I'm thinking. If is this is the case would I just need a new pressure. Would 6 puck still work

[SLOWR/T]

if you bought it all together send it all back together. if you have the money it isnt a bad idea to get a lighten flywheel while your putting in a clutch.

[Importdreamer56]

chnco and I tried to modify it...can't return it now