HELP!!!

[FlipKing]

Just did a clutch and tranny swap, and when i restarted the car I couldnt idle for anything and the throttle responded slowly. Lots of rubber is dry rotted on my 91 SE-R so is this a vaccume leak?

[Clegger]

http://buildllc.files.wordpress.com/2007/12/toys_02.jpg

I hope this helps

[TEG90]

yeh u might wanna check all the lines for cracks or hole to c if there leaking or sucking air. check make sure u didnt forget to plug any thing back in or hook in any wrong hoses?

[Barefoot]

http://buildllc.files.wordpress.com/2007/12/toys_02.jpg

I hope this helpslol wtf

get it to a shop let them do a leak test if they have the machine.

or

get your manual out check all your vac routes.

[d16_turbo]

check the MAF

[WHT_EP3]

just open the hood and try to listen in on a sucking or blowing sound cause it sounds like you gotta a vac. leak buddy "especialy around the intake manifold"

[AnthonyF]

maybe you just have a ground loose somewhere. Check your grounds

-Ant.

[Barefoot]

maybe you just have a ground loose somewhere. Check your grounds

-Ant.oo yup i didnt even think about that

[AnthonyF]

^ since it was just a tranny swap, I am pretty sure it is that or he pinched a wire putting the trans in.

-Ant.

[Tech5]

make sure your MAFS is plugged in

[FlipKing]

it ended up being a vac hose hooked up to the Charcoal box or w-e its called.lol. Im still learning all this crap. anyone know how to tighten up a cable driven clutch? My clutch doesnt engange til im in the floor.

[Barefoot]

happy u got it going. im not sure how to adj yours sry. im sure somebody else will know.

[Black4DrEK]

there should be a knob like thing that you turn and it tightens the cable.

[FlipKing]

Thats as tight as it can go,but my clutch still doesnt engange til im like an inch from the floor.

[TEG90]

u might need a clutch? but did u pull the cable up tight and then turn and tighten the knob down on the clutch lever?