View Full Version : CV axles replaced, still ticking noises... watf?
changaroo
05-29-2008, 05:38 PM
soo...
i had a busted passenger side cv boot, and today i replaced the whole axle.
...and my damn car still makes a clicking/ticking noise. i have no idea what it could be now.
the only thing i did before this was rotors / replace pads. and that was last week.
what could the ticking be? any idears?
thanks
:)
Barefoot
05-29-2008, 06:29 PM
the axle may not be locked in. the other axle may be bad.
csmiths
05-29-2008, 06:47 PM
i dont know when i heard it last night, it only sounded like an axel click, but could it be the other one.
tubby
05-29-2008, 06:56 PM
im kinda havin the same problem but im only geting it wen my foot is off the clutch and im under a load. kinda weard. im stumped
.blank cd
05-29-2008, 07:21 PM
What are you driving?
changaroo
05-29-2008, 07:28 PM
What are you driving?
you shall see on sunday :D
.blank cd
05-29-2008, 07:29 PM
you shall see on sunday :D :thinking:
patrick4588
06-01-2008, 09:41 PM
maybe dust shield on the rotor? maybe?
Kaiser
06-03-2008, 08:16 AM
When the boot died it could have damaged the transaxle/diff? Does it do it in straight lines, or when turning?
1SOL2NV
06-03-2008, 04:43 PM
push the axle in further ..... or replace the other axle ... problem should be solved .
Benefit
06-03-2008, 04:44 PM
wheel bearing?
Scotsman
06-03-2008, 04:55 PM
push the axle in further ..... or replace the other axle ... problem should be solved .x2
mikesEK
06-04-2008, 09:17 PM
x3
x2
if it popped out again. Check your Engine Mount. if its going back it can pop it right back out or cause it to break again.
Changaroo, put the camera down and give us an update :)
-jonathan
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.