View Full Version : Ignition timing
GSRtegŪ
05-21-2008, 08:10 PM
I was wondering how you set the ignition timing to 12 degrees?
I have a D16Y8 that's stock
The ECU is a P28 chiped for the Y8
Scott told me to run the car to running temp and to connect a pin to the service connector. Then us a timing light to check and change it? What would I move the dizzy or what?
Any help would be good thanks in advance. :goodjob:
Tech5
05-21-2008, 08:15 PM
Yes you can move the dizzy but by so far...an you look at the lower timing cover there is a timing tab an then you use the red line on the crank pulley with timing light set the light to zero an then dial it in ...
Barefoot
05-21-2008, 09:17 PM
Yes you can move the dizzy but by so far...an you look at the lower timing cover there is a timing tab an then you use the red line on the crank pulley with timing light set the light to zero an then dial it in ...thats it:cheers:
GSRtegŪ
05-21-2008, 10:22 PM
Yes you can move the dizzy but by so far...an you look at the lower timing cover there is a timing tab an then you use the red line on the crank pulley with timing light set the light to zero an then dial it in ...
Ah, so basically what you are saying is line up the red mark with the timing tab with the timing gun... :goodjob:
Barefoot
05-21-2008, 10:55 PM
yes
GSRtegŪ
05-21-2008, 10:56 PM
yes
Damn that was the strait foward answer I have been looking for all day. :goodjob:
Tech5
05-21-2008, 11:48 PM
lol
Barefoot
05-22-2008, 12:03 AM
lol short and to the point
Tech5
05-22-2008, 12:04 AM
sometimes that is the best way to be
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.