Anyone use a VTEC harness on a non-vtec motor?

[LongLiveH2b]

Anyone use a VTEC harness on a non-vtec motor?

i gotta obd1 SOHC vtec wiring harness(D16Z6) original car 92 SI hatch

bout to put an obd1 LS in it w/ P75 ecu(LS), just wonderin if i can use the harness without any electrical issues no vtec solenoid, CEL's, etc.

What if i were to use a chipped ECU?? tune it, would that be different cuz u can disable some settings??

REPS:goodjob: to any kind of help.........THANX IA

[Barefoot]

it will work without any problems. your going to have some wires hanging off to the side. they wont casue any issues.

[LongLiveH2b]

You must spread some Reputation around before giving it to no mo hondas again.


THANX

[Barefoot]

np happy to help

[Tech5]

It will have a check engine light on for the vtec stuff
it will work without any problems. your going to have some wires hanging off to the side. they wont casue any issues.

[green91]

only if he is running the wrong ecu. if he is running a ls ecu it should be fine.

[Tech5]

am the dumbass

[green91]

then he is dumb for even trying to use that ecu with a LS.

[LongLiveH2b]

then he is dumb for even trying to use that ecu with a LS.

it's just the harness!!!! motor is OBD1 LS w/ OBD1 LS ECU!!!

[Barefoot]

if you read his post he is using the ecu also its a 92 si ...
lol if u read his post u will see


bout to put an obd1 LS in it w/ P75 ecu(LS) he is going to be using an ls ecu

[green91]

i was responding to joshua's post.

[Tech5]

My bad am the dumbass lol I thought I saw ecu an harness my bad