View Full Version : Where to get a driveshaft/u-joint rebuilt?
Stormhammer
04-23-2008, 08:43 AM
Anyone know of a place that can replace/rebuild u-joints on a driveshaft around Gwinnett County?
seanrg1116
04-23-2008, 09:58 AM
try a metal shop
RWD164
04-23-2008, 09:58 AM
You got a vise in your garage? This is all you really need. There is a place on Pleasant Hill Road Across from Best Buy that may work on your car.
MA
Stormhammer
04-23-2008, 10:06 AM
Hmm... I was reading a DIY but I wasn't sure if there were reputable shops that did it with warranties etc :D
Barefoot
04-23-2008, 10:21 AM
there is a really good drive shaft shop in forest park over by the base. that is if your willing to drive that far.
Custom Drive Shaft & Hydraulic
2150 Moreland Ave SE # B
Atlanta, GA 30315
(404) 622-2800
Stormhammer
04-23-2008, 01:55 PM
Hm, I'm going to attempt it myself after reviewing the FSM. Saves me $$$ :D
Jaimecbr900
04-23-2008, 01:58 PM
There's a driveshaft shop over off Buford Hwy, almost right across from Z car of Atlanta. I'm not sure if that's considered Norcross or Doraville. It's a hole in the wall place, but they are very good and that's all they do. :goodjob:
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.