Rebulding the ZC part 1

[Athens_Red_Rexin]

Decided to rebuild the ZC. It was smoking a little, and wanted to make it more reliable.
http://i28.tinypic.com/muwn6t.jpg
Taking out the cams to get to the headbolts.
http://i32.tinypic.com/2udw7r8.jpg
http://i32.tinypic.com/10oqkk6.jpg
Here is my perfect circle rings and rod bearings and felpro seals.
http://i26.tinypic.com/35isw8g.jpg
All 4 cleaned and ready for new rings and new rod bearings.
http://i28.tinypic.com/a59m68.jpg
Before honing.
http://i30.tinypic.com/311kt9j.jpg
After honing. :goodjob:
http://i26.tinypic.com/66hno9.jpg
http://i27.tinypic.com/jzfa6h.jpg
New rings.
http://i31.tinypic.com/2d9usdt.jpg
Got em back in with new rings and rod bearings. No more smoking!!! :bump:
http://i26.tinypic.com/2a0hpaf.jpg
Putting the the new valve seals.
http://i32.tinypic.com/2d97csg.jpg
Valve spring locks.
http://i30.tinypic.com/69gm1f.jpg
Removing the valve spring.
http://i30.tinypic.com/2w7enbk.jpg
The old valve seal. These things are such a ***** to get off!
http://i31.tinypic.com/vdic7b.jpg
The new one.
http://i27.tinypic.com/2a813pc.jpg
Ready to go!
http://i25.tinypic.com/29vctnn.jpg

I will have more pics, hopefully at the end of this week. Some pics of relocating my new Odyssey battery into the rear, and some more motor pics and my new Magnaflow muffler install. :bannana::bannana::bannana::bannana:

[sakasaku]

nice i am starting my rebuild on my b18b this week!

[N/A EK]

thats now mine was when I took it apart... but its all good now.

[green91]

Not to bad, i went with NPR rings, ACL bearings and head studs on my rebuild. The valve stem seals aren't to bad if you have the correct pliers :)

[Athens_Red_Rexin]

Check out part 2!