PDA

View Full Version : FS:d16a6



revsdr
03-03-2005, 08:55 PM
has valve rattle....
best offer...or trade.
located in griffin

japan4racing
03-03-2005, 09:00 PM
what all is included. i gotta freind looking for a motor. is the bottom end good? would you sell just the bottom end?

revsdr
03-03-2005, 09:02 PM
has everything but trans,and throttle body.
bottom is good.
make offer.

Soloboy
03-03-2005, 09:20 PM
Pretty sure if you get a Valve Adjustment then it might be Ok... Have you been Over Revving the Motor?!

revsdr
03-03-2005, 09:28 PM
no the timing belt broke.
so i bought a zc dohc for it.
i pull the d16a6 today and will install all my new parts
on the zc tomorrow.
will get the zc ready to put in tomorrow......
heres a list of expences so far...
pacific engines dohc zc -$800
pace setter header-$150
daikin clutch kit "exedy"-$117
vaccumn hose kit "red"- $22
accel wires- $35
rywires distributor harness
plug and play - $40 + $14 for over nighting both ways
intake gasket-$22
brake rotors-$70
pads-$34
02 sensor-$40
exhaust gasket-$20
timing belt-$48
oil filter-$4
upper radiator hose-$10
anti freeze-$10
mobil1-$20
ngk plugs-$8
distributor cap-$20
rotor button-$9
pvc valve-$7
thermostat & gasket-$15
water pump-$48
valve cover kit -$20
wiring loom"red"-$20
hand cleaner,break cleaner,high temp paint,
penetrating catalyst.,red zip ties,
and i still have to get new motor and trans mounts tomorrow.

sicivic89
03-03-2005, 09:45 PM
what kind of mileage? did it burn any oil?

revsdr
03-03-2005, 09:51 PM
180,000 miles, used no oil.
didnt smoke,ran strong.
i would keep it and get the head fixed,but
im selling to off set some of my expences.

i also have a b18a engine ,trans,ecu,shift linkage,etc.
and a 90 crx si runs great.
make offers on those as well.
[email protected]