View Full Version : is this good or bad...
just realize that the bolt that hold the mount punch a whole into the block...is this okay or well it be worst in the future...
http://i136.photobucket.com/albums/q170/slor209/block3.jpg
http://i136.photobucket.com/albums/q170/slor209/block2.jpg
http://i136.photobucket.com/albums/q170/slor209/block1.jpg
redrumracer
02-26-2008, 05:28 PM
wow thats deff not a good thing just throw some sealant on it and it should be fine id think since its just a waterjacket
but just out of curiosity, why didnt you stop when you noticed that it was gettin harder to turn?
eghonda88
02-26-2008, 05:29 PM
Not totally sure but I would say no. Just because its supposed to be enclosed but it might be fine if nothing major gets on it or if it releases any dirt or metal chips you know
i bought the motor and was cleaning it and i saw it like that already...
NAIZBST
02-26-2008, 05:56 PM
you can use a sealer or jb weld for it, but it is just a coolant jacket so it wouldn't be that bad...go to an auto parts store and ask them about it
kainkauz
02-28-2008, 09:55 PM
i think it will be ok at least it did go all the way to the pistons
japan4racing
02-28-2008, 11:29 PM
once the coolant system has pressure on it you will have a leak...if that block was mine i would toss it in the trash. totally worthless
Pavlo
02-28-2008, 11:33 PM
Have somebody Tig weld the whole from the inside, JB weld will crack over time from hot/cold cycles and pressure.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.