PDA

View Full Version : B18B1 block


boostedy8
02-10-2008, 11:53 AM
I just went to put on my new headgasket and discovered that the #3 cylinder is cracked:( So I am in need of a bare B18B1 block w/ or w/o crank. But I need all of the main caps. It dosent matter if everything is rusted cause I am going to bore it out to 81.5 mm. Just let me know what you have. Thanks:goodjob:
Tech5
02-10-2008, 01:22 PM
pm'ed
EmminoDaGreat
02-10-2008, 01:23 PM
too buch boost 4 chu
silversol
02-10-2008, 02:10 PM
pmed i have a perfect short blockasking 250$
boostedy8
02-10-2008, 03:12 PM
too buch boost 4 chu

No just a bad tuner. The motor only had about 400 miles on it when the gasket went. I was using one of the best engine management systems out there the HKS F-CON and had my boss that thought he knew what he was doing but I guess not. I had my car tuned at Mainstream for over 3 months and the car ran perfect. The only reason that it ran for only three months was cause I had my turbo re-built and had to fix my crappy head. Don't ever buy someone elses mistake. :goodjob:
EmminoDaGreat
02-10-2008, 03:15 PM
looks like you should come let us tune it again ;]
Da_unknown
02-11-2008, 04:17 PM
word....
b18cEG
02-11-2008, 10:28 PM
got a bare gsr block?
trickteg
02-12-2008, 12:55 PM
I have a B18B1 Long block and a turned crank I would let go for $350. The crank cost $150 to have turned. Let me know,
thanks
boostedy8
02-16-2008, 07:42 AM
Still need a block. Not willing to spend over $100 on just the block. I have to bore and hone the block so if its rusty it dosen't matter. 4043745881:goodjob:
DarKStaR
02-16-2008, 10:28 AM
i got a full b18b(block and head) with rodknock for $300
boostedy8
02-16-2008, 05:40 PM
I just need a bare block. No heads or crank or even pistons and rods. Just the block. I am not looking to spend a fortune on stuff that I have no use for. So for people to think that they can get $250 or higher for a short block w/ rod knock your out of your mind. Its almost to the point to which that motor is a boat anchor. If you read the main post and then you would know that all I need is just a bare block. Thanks for all of the rod knock blocks that are charging an arm and a leg for but no thanks!:???:
boostedy8
02-17-2008, 09:41 AM
bump
Tech5
02-17-2008, 11:12 AM
I try to re-turn your call an didnt answer , i still got the i told you about,call me back bro
Just_CHill
02-18-2008, 09:14 PM
emailed