View Full Version : Integra compression help.!??
DaRussian
01-19-2008, 04:30 PM
Does anybody know the compression that should be in a b18b1 motor? i dont need the ratio, i need the compression in PSI ? does anybody know it? my engine is showing around 150psi in all 4 cylinders and its not running right...
boosted b
01-19-2008, 04:38 PM
it shouldn't exceed 199 psi or be lower than 135 psi in a b18b1
DaRussian
01-19-2008, 04:44 PM
it shouldn't exceed 199 psi or be lower than 135 psi in a b18b1
ok thanks, so my compression is good then... because it shows around 150 in all 4 cylinders.
boosted b
01-19-2008, 04:45 PM
how is it running
DaRussian
01-19-2008, 04:48 PM
how is it running
i think that it must be running rich or something, because when i drive it does not pull at all, has no power. it idles good, but when i rev it up it starts to misfire or something i dont even know
boosted b
01-19-2008, 04:50 PM
when was the last time u tuned it up or what kinda gas have u put in it lately
DaRussian
01-19-2008, 04:53 PM
when was the last time u tuned it up or what kinda gas have u put in it lately
i didnt tune it, filled up at qt before i didn the swap. i just put it in my hatch like a week ago
boosted b
01-19-2008, 04:55 PM
was it running ok before u put it in or u don't know
DaRussian
01-19-2008, 05:00 PM
was it running ok before u put it in or u don't know i thought it did. it sounded pretty good but the car wasnt drivable so i couldnt check,
boosted b
01-19-2008, 05:37 PM
without really lookin at it all i could really do is guess but start with the tune up
GAtegs
01-19-2008, 06:04 PM
An LS SHOULD somewhere around 175-180 psi. 150 is kinda low.
green91
01-19-2008, 06:08 PM
even though 150 sounds a little low it should run fine with that compression.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.