Mr. Clean
12-20-2007, 10:17 PM
SOLD! and spent at autozone already haha
THIS IS A B-SERIES HEADER!!
header has some issues but all of which could be corrected im sure (read further for explanation and pricing)
this is a spoon replica header, it has a little spoon badge and everything haha.
i pulled it off of a b16 but had to extend the the o2 sensor wire to fit in the hole because on a factory b16 header it is under the motor but on this header its up on top toward the valve cover.
condition of the header:
it has a scrub on one pipe but its not too bad, it dented it just a little.
its a 2 piece and where the two pieces meet the screws are weird and the gasket is only half there. but other than that it's a perfectly useful header and a definite upgrade from a manifold.
give me $75 bucks and i'll drive a little ways. not too far though, maybe a 15-20 minute trip to meet somebody would be ight. im in gainesville by lakeshore mall.
pics:
THIS IS A B-SERIES HEADER!!
header has some issues but all of which could be corrected im sure (read further for explanation and pricing)
this is a spoon replica header, it has a little spoon badge and everything haha.
i pulled it off of a b16 but had to extend the the o2 sensor wire to fit in the hole because on a factory b16 header it is under the motor but on this header its up on top toward the valve cover.
condition of the header:
it has a scrub on one pipe but its not too bad, it dented it just a little.
its a 2 piece and where the two pieces meet the screws are weird and the gasket is only half there. but other than that it's a perfectly useful header and a definite upgrade from a manifold.
give me $75 bucks and i'll drive a little ways. not too far though, maybe a 15-20 minute trip to meet somebody would be ight. im in gainesville by lakeshore mall.
pics: