View Full Version : ls vtec torque spec
i need help with torque spec on rod bolts and main bearing bolts ... also need head bolts spec on a ls vtec with gsr arp head bolts..
blown_ss
11-14-2007, 11:45 PM
i need help with torque spec on rod bolts and main bearing bolts ... also need head bolts spec on a ls vtec with gsr arp head bolts..
it would be the same as the book says. look it up. its not as hard as you are trying to make it. they are not different. gl.:goodjob:
JDM onlyy
11-15-2007, 01:02 AM
you mean ARP head studs? those you're suppose to tighten into the block hand tight, so use the allen key and tighten and when it gets tight, turn it a 1/3 of a turn counterclockwise so it isn't too tight. And just tighten the nuts on the studs the same torque spec.
i just need some numbers ...
blown_ss
11-15-2007, 07:37 AM
look it up. just use the stock torque specs.
if your using stock LS rodbolts and mainbolts . . its going to be Mainbolts ( 51 lbs ) Rodbolts ( 23 lbs ), arp headstuds for GSR? hit up arp and see the process of installing them
killerdx
11-16-2007, 07:31 PM
^^the first person to actually answer your question, :goodjob: reps for joo
lol i mean seriously, all he asked for was some silly numbers
Vteckidd
11-17-2007, 10:49 AM
ARP HEadstuds are 70 ft/lbs
Mains IIRC is 51ft/lbs
Rod Bolts should be 29ft/lbs if they are ARP
SPOOLIN
11-17-2007, 11:00 AM
main bearing caps torque to 56 ft lbs in b18a/b
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.