b16... problem... again....

[b16ftw]

ok so... my b16's leakin oil out from around the head and i think it's leaking coolant as well.

i would assume that the headgasket's ****ed up but i just replaced it about a month ago with a nice buddy club one.

any help would be appreciated.

[speedminded]

General Tech?

[Schugg]

did you surface the bottom of the head, and top of block before you put it back together? if it blew a head gasket before it probably got hot enough to mess up the surfaces.

[lsi-crvtec]

..........

[AnthonyF]

buddy club HG...?? i would have went with cometic or OEM.

prob when u did ur HG u messed up something else.

[The Ninja]

block/hg needs resurfacing. Have you been driving it hard?

[Grimm Reeper]

and was is also torqued down to the right specs

[revsk8erdude]

make sure you have the right spec gasket and tighten everything down.

[Barefoot]

couple of things did u straight edge the head and block to make sure they was warped. when u pulled the head off did u take the head bolt off in the right order so that u dont warp the head anymore. when u reinstalled did u get new head bolt/studs or reuse the old 1. did u after putting a few 100 miles on it go back and recheck the tq on the head bolts/studs.

[wrekonize]

shoulda use new head bolts and pleanty of thread lock...recheck the torque specs

[87 Turbo II]

it kind of contradicts your screen name. Good luck with it.

(I feel stupid, I don't know all the engine codes, what engine is the B16?)

[eghonda88]

It sound like your head gasket is on wrong. Is it only shooting out of the back of the head near the gasket?

[khailon]

thats sucks