****ty turbos or ok to buy?

[LeX]

Looking for a good but inexpensive turbo for my project car.

Going to be using stock T3 exhaust manifold but with 3" exhaust and custom downpipe. Will be using engine management. Just something decent for a 2.8L motor looking for some good power boosting no more than 14psi with an intercooler. Looking for the best power but also decent spoolup time.

Do any of these turbos look like they could be a good bet or will the quality just be too ****ty? they dont look all that bad imo

http://cgi.ebay.com/ebaymotors/T3-60-1-BIG-SHAFT-AR70-COLD-AR63-HOT-TURBO-CHARGER_W0QQitemZ190168581146QQihZ009QQcategoryZ33 742QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
http://cgi.ebay.com/ebaymotors/Turbocharger-T-70-70-A-R-83-Trim-Stage-4-IV_W0QQitemZ220151945572QQihZ012QQcategoryZ33742QQ rdZ1QQssPageNameZWD1VQQcmdZViewItem
http://cgi.ebay.com/ebaymotors/T70-Stage-4-Turbocharger-Turbo-70-A-R-T-70_W0QQitemZ170164641125QQihZ007QQcategoryZ33742QQ ssPageNameZWDVWQQrdZ1QQcmdZViewItem

http://cgi.ebay.com/ebaymotors/T3T4-Stage-Stg-4-Turbo-Ford-GM-Ecotec-Honda-Nissan-DSM_W0QQitemZ180173194959QQihZ008QQcategoryZ33742Q QssPageNameZWDVWQQrdZ1QQcmdZViewItem

or a smaller one

http://cgi.ebay.com/ebaymotors/T3T4-Stage-Stg-2-Turbo-Ford-GM-Ecotec-Honda-Nissan-DSM_W0QQitemZ180173194944QQihZ008QQcategoryZ33742Q QssPageNameZWDVWQQrdZ1QQcmdZViewItem

[Big J]

I ran one for a while, no problems, I've had a couple of friends run them at high boost for a while, w/ no problems.

When I ran my Ebay turbo I was pushing about 4 PSI on stock injectors, it was a "T3/T4 57 trim .63 hot side stg 3"

I tried the stock injectors a 4psi on my 50 trim Turbonetics turbo and and was more than maxing out the injectors, that should say something.

They work fine but have a tendency to flow less than a comparable brand name turbo.