Ltdnismorace
10-14-2007, 12:10 PM
NOW RUNNING... HAS A VACUUM LEAK CAUSING A VARIATING IDLE, BUT IT RUNS :D
Only issue is the two front wheels have been stripped and need to be painted white to match the rears and the rear hatch was swapped after painted the outside so it is red and does not match, however the inside of the hatch was painted when the inside was done. Never know what might strike my interest as long as it's running, I'm tired of having a paperweight in my garage. The footwork will have to be done by the other person as my job in Special Ops does not allow me the ability to travel. My driveway has a downhill slope towards the door and I can't push the car out to get full side shots by myself, so I took what I could to show dentless quarters, fenders, and doors.
7.5k includes everything for straight up cash, trades must be running and have heat, A/C is prefered but not mandatory. S10/Sonomas, S14 5 speeds, **** whatever throw me some offers. Again, I work Special Ops for the state of west virginia division of corrections and am on call 24 hours a day, 7 days a week so traveling for me is out of the question, footwork would HAVE to be done by the other party, for this I apologize in advance but I am being very open and honest about it.
VIN # availible upon request, first mod to see this PM me and I'll give it to you, I haven't been on here in a while and don't know which mod is handling it now.
engine-sr20det /5spd
recently rebuilt (maybe ~1000 miles on it)
new head from nissan
new oem parts - all bearings/valves/valve stems/ seals/gaskets
timing chain/timing chain tensioner
pcv valve
water pump
oil pump/timing chain cover
crankshaft angle sensor
power super v belt
coolant temp sensor
knock sensor
hks 264 intake/264 exhaust camshafts (stage 2s)
peak performance pro valve springs
greddy rocker arm stoppers
apex'i metal headgasket
arp rod bolts
arp headstud kit
pro-fab design intake manifold gasket
nismo adjustable fuel pressure regulator
walboro 255lph fuel pump
nismo thermostat
S13 JDM SR20det ECU
megan racing exhaust
Trunk relocation kit for battery
hks ssqv
front mount intercooler
Greddy catch can
nismo oil cap
nismo radiator cap
powdercoated valve cover
carbon fiber spark plug cover
chrome valve cover nuts
act street/strip clutch
fidanza flywheel
earl's stainless clutch line
s14 brake booster/mbc
D2 coilovers
spl tension rods
c-pillar bar
Volk Daytona 17x7 +35 all around (run a 25mm spacer all around for finished offset of +10)
215-40-17 federal 595rs
Circuit Sports Hood Damper kit
JGY Oil Feed line with inline restrictor
Circuit Sports Coolant feed and return lines
Perfect S14 seats with Sparco Harnesses
Sparco Hood pins (uninstalled)
Greddy Turbo Timer
Greddy Profec Boost Controller
Razor WB402-CJ Alarm w/ Keyless Entry
Eclipse 55040 CD Player
Memphis MClass 15-MC46 4x6 Front
Memphis MClass 15-MC46 4x6 Rear
MTX Thunder Series 4244
Depending on trade, I also have a complete unmounted URAS style aero kit.
http://i35.photobucket.com/albums/d186/Lilredrover/aero1.jpg
I also have an extra head, other various extra parts, valve springs, extra exhaust, a set of corbeau seats, etc. On to pics. Some are old, some or not. The interior photos with the white steering wheels are the most recent.
http://i35.photobucket.com/albums/d186/Lilredrover/whatever015.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever013.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever010.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever009.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever008.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever005.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever001.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/radioboost.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/defi.jpg
Only issue is the two front wheels have been stripped and need to be painted white to match the rears and the rear hatch was swapped after painted the outside so it is red and does not match, however the inside of the hatch was painted when the inside was done. Never know what might strike my interest as long as it's running, I'm tired of having a paperweight in my garage. The footwork will have to be done by the other person as my job in Special Ops does not allow me the ability to travel. My driveway has a downhill slope towards the door and I can't push the car out to get full side shots by myself, so I took what I could to show dentless quarters, fenders, and doors.
7.5k includes everything for straight up cash, trades must be running and have heat, A/C is prefered but not mandatory. S10/Sonomas, S14 5 speeds, **** whatever throw me some offers. Again, I work Special Ops for the state of west virginia division of corrections and am on call 24 hours a day, 7 days a week so traveling for me is out of the question, footwork would HAVE to be done by the other party, for this I apologize in advance but I am being very open and honest about it.
VIN # availible upon request, first mod to see this PM me and I'll give it to you, I haven't been on here in a while and don't know which mod is handling it now.
engine-sr20det /5spd
recently rebuilt (maybe ~1000 miles on it)
new head from nissan
new oem parts - all bearings/valves/valve stems/ seals/gaskets
timing chain/timing chain tensioner
pcv valve
water pump
oil pump/timing chain cover
crankshaft angle sensor
power super v belt
coolant temp sensor
knock sensor
hks 264 intake/264 exhaust camshafts (stage 2s)
peak performance pro valve springs
greddy rocker arm stoppers
apex'i metal headgasket
arp rod bolts
arp headstud kit
pro-fab design intake manifold gasket
nismo adjustable fuel pressure regulator
walboro 255lph fuel pump
nismo thermostat
S13 JDM SR20det ECU
megan racing exhaust
Trunk relocation kit for battery
hks ssqv
front mount intercooler
Greddy catch can
nismo oil cap
nismo radiator cap
powdercoated valve cover
carbon fiber spark plug cover
chrome valve cover nuts
act street/strip clutch
fidanza flywheel
earl's stainless clutch line
s14 brake booster/mbc
D2 coilovers
spl tension rods
c-pillar bar
Volk Daytona 17x7 +35 all around (run a 25mm spacer all around for finished offset of +10)
215-40-17 federal 595rs
Circuit Sports Hood Damper kit
JGY Oil Feed line with inline restrictor
Circuit Sports Coolant feed and return lines
Perfect S14 seats with Sparco Harnesses
Sparco Hood pins (uninstalled)
Greddy Turbo Timer
Greddy Profec Boost Controller
Razor WB402-CJ Alarm w/ Keyless Entry
Eclipse 55040 CD Player
Memphis MClass 15-MC46 4x6 Front
Memphis MClass 15-MC46 4x6 Rear
MTX Thunder Series 4244
Depending on trade, I also have a complete unmounted URAS style aero kit.
http://i35.photobucket.com/albums/d186/Lilredrover/aero1.jpg
I also have an extra head, other various extra parts, valve springs, extra exhaust, a set of corbeau seats, etc. On to pics. Some are old, some or not. The interior photos with the white steering wheels are the most recent.
http://i35.photobucket.com/albums/d186/Lilredrover/whatever015.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever013.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever010.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever009.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever008.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever005.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/whatever001.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/radioboost.jpg
http://i35.photobucket.com/albums/d186/Lilredrover/defi.jpg