View Full Version : Hydro clutch in a cable tranny?
I <3 my EF
09-19-2007, 09:14 AM
Can I use a hydro clutch/pressure plate in a cable tranny? Just wondering.
mxglory258
09-19-2007, 09:36 AM
I'm not sure myself, but go to like autozone.com and cross part numbers from the calbe, to the hydro one. Chances are they're wrong, but might not be. It's a start. Sometimes though, they'll have diff. part numbers, but infact be the same general part.
mxglory258
09-19-2007, 09:37 AM
They splines also vary. I had 2 pressure plates at one point, and one was one spline less or something like that.
Good luck either way!.
I <3 my EF
09-19-2007, 10:29 AM
I was just thinking about doing that. But just wanted a sure answer. Thanks.:goodjob:
bigdare23
09-19-2007, 10:31 AM
nope
crhatchzc
09-29-2007, 01:31 AM
it depends on what cable tranny you have
green91
09-29-2007, 12:08 PM
if your trans is 89+ then yes. i used a EG (92-95, hyrdo) clutch on a 91 Si trans with no problems.
AMD_Civic
10-02-2007, 01:24 PM
nope their lying dude.. doesn't work...
green91
10-03-2007, 07:17 AM
yes it does, i did it on my own car. if you dont know what the **** you are talking about then please dont try to give advice.
AnTi-PooN
10-08-2007, 10:12 PM
pwnd ef squad prevails
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.