I'm replacing a toyo's carburetor tomorrow....Any tips?

[madking411]

I'm goin to the junkyard tomorrow to replace the carburetor in my mom's old car. Its an 89/88 toyota corolla wit over 220,000 miles on it. Still runs pretty good, but can only go for a little less than a mile before it sputters like CRAYZYEEE, and then dies. So, im gonna rip a 'better' carb from the junkyard and stick it in there.

Does anybody have any tips or suggestions before i go for it?:goodjob:
(....other than labeling all the vacuum lines....)

[madking411]

bumpin up one.....

[allmotoronly]

try rebuilding the carb you already have. You can probably find a kit for cheap, and then it should run better than if you put a carb on that has been sitting in a junkyard with old gas in it.

[madking411]

well, this is an Aisan carburetor.....even trained mechanics say its REEALLY hard to rebuild those and that its better to just get one from the yard..

[iEvo]

clean the new 1 really good before u put it in just to make sure theres no shit in it to give u the same problems as the old 1