Headers for B16a

[Papa_Smurf]

yup. My dad wants to buy some headers for his b16, preferably 2 piece... well, only 2 piece unless you could get a 1 piece in without taking the motor out. also the oxygen sensor needs to be higher up. It's for a b16a in a 90' civic hatch.

[i4_garage]

got a brand new JG edelbrock header for 225 LMK

[Papa_Smurf]

PM'd

[Sol-Badguy]

HeadeR.

[Papa_Smurf]

lol w/e, you get what i'm looking to buy...

everyone on this site just has to be grammatically correct, don't they?

[OG-Skinny]

2-piece is the only one that will fit w/o taking the front crossmember out. Or get a Traction bar setup that will remove the heavy ass stock one.

[bigdare23]

2-piece is the only one that will fit w/o taking the front crossmember out. Or get a Traction bar setup that will remove the heavy ass stock one.

I'm rocking a greddy 4-2-1 one piece (from a civic si) and it fits good with the crossmember intack. I "believe" if he uses a 1.6 header he shouldnt have any problem, but 1.8/2.0 header wont clear the crossmember, but I could be wrong..............

[bigdare23]

yup. My dad wants to buy some headers for his b16, preferably 2 piece... well, only 2 piece unless you could get a 1 piece in without taking the motor out. also the oxygen sensor needs to be higher up. It's for a b16a in a 90' civic hatch.

Is he's car obd0 or 1? If it's obd0, I couldnt find any headers with two o2 sensor wholes when I did my swap.

[Papa_Smurf]

i think his is obd1 then, because he was just concerned about 1 oxygen sensor...

my dad seems to that if he splices the wires and extends it to reach a bung located on the 2nd piece that it will give him false readings and therefore not pass emmisions.

true or false?

[Papa_Smurf]

scratch that, his is OBDO. He said he only runs 1 oxygen sensor though. he said the car never ran right w/ both of them in, and would only pass emissions with 1 sensor in.