View Full Version : b16 head
SleeperWRX
05-20-2007, 10:14 PM
Ok So I orderd a b16 head that I will be adding on b18a block I got everything with the head expect the distrubrator and CAMS . What else will I need..... I got the complete head.
mxglory258
05-20-2007, 10:17 PM
Hmm...you can do that?? I was told you can't put a B16 on a B18 block. that you had to bore the B16 block to get what your going for....
Obviously u need dist. and cams...and gaskets.
SleeperWRX
05-20-2007, 10:37 PM
Hmm...you can do that?? I was told you can't put a B16 on a B18 block. that you had to bore the B16 block to get what your going for....
Obviously u need dist. and cams...and gaskets.
I dont know about b18 head on b16 block but B16HEAD on b18 block should be fine as far as parts go I was thinking the Dist,CAMS and gasket everything else I got oo and of course "SPARK PLAGS" whoa
mxglory258
05-20-2007, 10:47 PM
I dont know about b18 head on b16 block but B16HEAD on b18 block should be fine as far as parts go I was thinking the Dist,CAMS and gasket everything else I got oo and of course "SPARK PLAGS" whoa
Sorry, I meant a B16 head on an 18 block. I could've been told wrong.
I was going to pick up a B18, and put my 16 head on it. Then When I questioned it, I was told I couldn't.
d16_turbo
05-20-2007, 11:07 PM
it will work you will just need a b16 head gasket dowl pins and you need oil line to run up to the head
SleeperWRX
05-21-2007, 07:09 AM
Sounds simple
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.