a question?

[santacruz77]

ok im new with for motors, i was wondering if i have efi 5.0 can you bolt on the intake manifold and carb of a carbed 5.0? wil it fit or can you buy intake manifolds to swap?

[JRDman]

you jsut buy the carb manifold and set everything up for carb.

CJ

[on 3]

yes but why?

[santacruz77]

so i wouldnt have to wire anything up btw the stang in your sig is sexy as hell

[JRDman]

Just get it tuned if you do carb it. you can do it by ear if you have any idea of what your doing until you can get it to the dyno but TUNE THE BITCH when you get everything running. its a must for reliability and performance

[AnthonyF]

how could that work? if it is an EFI system, i dont believe it is possible. I believe u can pull ur EFI motor out and swap it for a carb'd motor. bc it does not require all the electronics

[JDM-95-Hatch]

it can be done, the blocks and heads will work fine as long as you have the carb manifold, seen it done. the motor itself doesnt require electronics, the fuel injection does

[santacruz77]

right so i can just get the intake manifold and carb then tune it and what not and like all the fuil injection goes right? cause im getting a 5.0 but id rather buy one out of later year and then swap to carb because of less miles and what not.

[jankestang]

you can run a carb but you have to buy a fuel system and what not. I recommend welding in a sump and running a cheap but still good holley blue pump. If you have a motor up to i think 91 it will have forged pistons and I have spryed 250 on stock stuff. car ran 7.20s with a 5 speed. lol

[jankestang]

if you are interested I have a decendly built little 306 longb lock for sale.