Custom GSR Throttle Bracket

[puregroove]

--did this today. It needed to be done. It'll work for now. I'm hoping to get better gas mileage compared to the rig I had before. :thinking: :goodjob:

Made from a piece of aluminum I had laying around and as you can see cx oem bracket. --and using the cx throttle cable.

Just wanted to share. Thoughts? Anyone else done something similar?

:camera:

http://puregroove.org/bracket01.jpg

http://puregroove.org/bracket02.jpg

[93H22ACX]

looks good man....as long as it works :)

[puregroove]

lol...show ya right::: :goodjob:

[vtecgsrguy]

YEAH.... LOOKZ LIKE IT WORKZ FINE? YA GIVE IT A TEST RUN FOR A MIN. YET??? GOOD JOB!

[puregroove]

^^^yea, response is a lot better. I think I'm going to have to tinker with the rotor spring, though cause sometimes the throttle stays open a little bit--meaning it doesn't go back down to normal idle.

[vtecgsrguy]

oh i bet....tendz to stick a little bit huh?.... i had that problem wit my GSR TB after JG bored it over.... i had to work with the spring a little... but turned out really well worth it!

[Vuongy_Dong]

as long as it works, its good to go.

[IntegraXTR]

speaking of which, I have a skunk2 manifold with a gsr throttle body, do I have to change the damn throttle body to a B16 so I can use the p73 bracket and throttle cable? been tryin to do this for a minute now.

[Dirty Octopus™]

wow...
thats exactly what i used to have b4 i got a custom one from some website that no longer exists.
nice work though :goodjob:

[AnthonyF]

try to cut it and make it nice a smooth for an oem look. Nice job though!

[EliteGSR]

nicely done mang

[puregroove]

Thanks, guys.


try to cut it and make it nice a smooth for an oem look. Nice job though!

Exactly what I was going to do--make it more shapely and round off the corners. I had to make quick work of it temporarily since it's my DD. :goodjob: