Crower Stage2's and AEM gears

[loneSTAR]

http://www.importatlanta.com/upload/files/275/P1030026.JPG
http://www.importatlanta.com/upload/files/275/P1030025.JPG

Were used for about 2000+/- miles.
It is recommended by Crower to upgrade valvetrain, i did not, only ran ITR springs and retainers. Used a 8200 redline (Cams had more potential past that rpm!) and took them out for something more gas friendly!

Stage 2
Stock idle lobes (sec/pri) with #63402 VTEC (mid) lobes.
Recommend #84163 spring unless stock rev limit.
RPM Range: Idle to 9250+
18+ hp over B18C
Int- 311 mid
Exh-308 mid Int- 255 mid
Exh-248 mid Int- 466 mid
Exh-466 mid

AEM cam gears (blue) Used for the same amount of time as the cams!

$350
Package deal, if you want the cams, they are $350 and you get free cam gears. Same goes for the gears. The cams are $600 alone....

[GsrME]

How much for the Cam gears, 350 also, your not willing to seperate?

[loneSTAR]

you are correct

[loneSTAR]

Bump

[mezzies96teg]

would these work well with a turbo setup on an LS? just lookin for some good ones man

[loneSTAR]

if its a LSvtec, more than likely (couldn't hurt). But if you are asking about a LS, then no, these are vtec cams

[Sammich]

IF u still have these in march ima get them

[loneSTAR]

Bump

[loneSTAR]

Bump

[loneSTAR]

Bump