All pics are hyperlinks, click on a pic to see the larger version!
All prices are OBO. Parts are located in Roswell, willing to meet for the larger parts. Only possible trades would be for 8th gen Si parts.
Best way to contact is email at [email protected]
My name is Sean
Darton sleeved H22A1 block. This is a closed deck block with 50mm main journals. The sleeves are the Darton flanged press in sleeves. Block is freshly decked and bored to 88mm. Was clearance for cast pistons mistakenly so there should be enough room to run it at 88mm with a fresh hone.
400obo
H22 head. The ports have been bowl blended by hand. Needs a valve job. Complete with cams.
100obo
APR H22 head studs. Torqued once, never ran.
100obo
H22 50mm mains crank. Already micropolished.
100obo
H22 eagle rods. Used but the big ends have been honed and are all in spec.
200obo
H22 VtecKidd RMF replica header. New and unused. Has a very slight dent in the exhaust flange as seen in pics.
300obo
88mm Wiseco pistons. 11.5 comp ratio. OK shape but useable.
150obo
H22 supertech valve springs. Installed but never ran. These are the 80lb seat pressure version.
SOLD
H22 full gasket set minus head gasket and valve stem seals.
20obo
H22 skunk2 stage 3 cams and skunk2 cam gears.
SOLD
GMB H22 water pump. New.
30obo
Ebay B series ramhorn. Has been rewelded and pressure tested.
50obo