Benen, Blox, Tial, AEM, Skunk2, Boomslang, DC Sports, Turbo stuff, LS, GSR, + more
I am currently in the process of moving and am trying to sell some stuff to lighten the packing load. All prices do not include shipping. I am paypal verified, all paypal transactions will incur the typical paypal fee. I am open to offers but don't lowball me to death. No warranty is expressed or implied on any part unless otherwise stated.
I am open to trades. I am looking for such things as aftermarket b16 springs and retainers, 1000cc injectors, b16 edelbrock victor x intake manifold, no china shit.... LS forged rods and low compression pistons (9:1).
I will be adding more as I go through my garage. I have 2 ls heads and 2 sets of ls cams about to go up, turbos, etc.
Benen front lower subframe bar (black) and front crossmember support bar (silver)
These are brand new, never installed on a car. Silver crossmember bar is still in bag, comes with Benen hardware, fits integra's and civic hatchbacks only (no coupes). Benen front lower bar was removed from bag to check ground clearance only, will not work for me as I'm way too low. Comes with benen hardware still in bag
Both Traded
Tial 46mm wastegate, has idle time only. Narrow body unit for more clearance. Comes with air fittings, fire ring and inlet/outlet bolts. No flanges. comes with a big yellow (.6bar) spring.
400 obo
Rare prof sheepdog blow off valve
Comes on a small section of 2.5" pipe, polished and in really good shape, prof logo is intact. Later version due to the flared trumpet.
175
AEM short ram intake. Came off my 97 EJ8, D16y8, may fit other applications. comes with K&N filter (need to be cleaned and re-oiled). Grey in color, still has CARB E.O. sticker.
90
P72 GSR tapped oil pan
Has 10-an fitting welded on for turbo drain line, however the fitting is all jacked up and does not work. No dents, just light scratches on bottom
50
GSR windage tray, new.
Has light surface rust from sitting but nothing a scotchbrite pad couldn't take off. never been in/on a motor
make offer (reasonable)
Compressor housings
Top housing, GT28R housing, came off s14 turbo.
Bottom housing, Fully Polished Garrett T3 60 Trim (only fits 60 trim t3's) .
GT28R - 125
T3 - 150
Nissan 60. trim t3 compressor housing
100
B series Blox type C cams
Have only 2000 miles on them, in mint condition. No cam gears
SOLD
Skunk2 test pipe
Previous owner welded up the o2 bung, not sure why. Not dents or anything just a little dirty
75
AEM adjustable FPR
Red in color, anodizing is fading and the vacuum nipple broke off somehow, still in working condition if the nipple is replaced
85
DC Sports 4-2-1 Ceramic coated header, b-series
Came off of my ls-vtec, no longer needed since Im getting my turbo setup done.
Has light surface rust from use, no dents in downpipe section, has small dent on one of the runners just off the head but its really really small. Will be broken down into 2 pieces for shipping purposes
200
Boomslang OBD1 to OBD2B conversion harness
Used for 1 week in my car. Still in brand new shape
sold
Stock GSR intake elbow
In perfect condition, just a little dusty
25
B16 Cams
Have 50,000 miles aprox. Came out of my 99 Si. Have 2 sets with cam gears
100 each
Reply With Quote
