h22 crx- bone stock motor.

[Sir_Christopher]

my h22a ef is about to beee tuned, i wouldnt mind a friendly run! i need good tires though

[KevinT707]

all I have is a cheap 100$ eBay header,50$ eBay short ram intake ..

See, I always knew eBay made high HP yielding parts!

This just in car an driver reports 2010 nissan gtr bone stock runs 11.3

then they took the car to Rome, ga and it ran 9.9.

Simply amazing

Haha. You is a funny white guy

[NEMO]

i want to know what this guy is doing. hell i am about the same power range and weight range as him and only ran a 12.6 on DR. my 60' were not as good as his though

[Arm&hammer]

It might just be a sick motor. my old bone stock prelude used to walk other preludes with i/h/e all day. Nice times man.

[Boostedek]

The generic rule is that it can be done and has been done not everything you read in a book is not always true.I am sorry your car can not do what mine does and that you can not drive so drop it already.every time I post a time or something you always say it can't be done because a book says so.you are more than welcome to come down when we take it apart and build it so you can see for yourself it is a bone stock motor.

good run man, its a guy on here (bee) run a 12.7-12.9 h22 in eg..i think he around 186 whp..so yea i think it possible for you to run that time in a crx..
good luck hope to see 11s

[SmackedInATL]

i want to know what this guy is doing. hell i am about the same power range and weight range as him and only ran a 12.6 on DR. my 60' were not as good as his though

LOL you just answered your own question. What are your 60s?

[Evil Goat]

^ exactly, for every tenth you lose off your 60' you lose anywhere from .15 to .2 seconds at the finish line

[atlplayerr]

SUPER DOOPER FAST....

[allmotorcrx]

my h22a ef is about to beee tuned, i wouldnt mind a friendly run! i need good tires though

sure anytime,i hope to be at steele on the 13th come if you can we can do it then

[allmotorcrx]

i want to know what this guy is doing. hell i am about the same power range and weight range as him and only ran a 12.6 on DR. my 60' were not as good as his though

ya 60' helps out when my 60' was 1.9 i ran 12.6s then 12.2 with 1.7

[allmotorcrx]

good run man, its a guy on here (bee) run a 12.7-12.9 h22 in eg..i think he around 186 whp..so yea i think it possible for you to run that time in a crx..
good luck hope to see 11s

ya i think with a little better r/t,tune my fuel in a little more,and higher rpm launch i can get that 1.6 60',and hopefully the 11s.

[h22 jones]

Im having trouble with fourth gear so i still havnt got a clean pass and i weigh about 500 more pounds than you do but by comparing your eigth mile times there is no way man im making 252 to the wheels now and there is no way. I have heard of some of these miricale motors from japan but if you tear it down i bet somebody built it in japan before you bought it or at very least its a stock type s. If you just bought it then you realy dont know if its stock or not honestly man. Im also 31 been doing this for along time and can drive the shit out of a car hell we can just bet reaction times if you want to im that confident in my driving (not saying you cant drive) just saying if you know as much as you say you do then you yourself know that something doesnt ad up . Thats just my two opion but personaly i think we need to just put my motor in your car since it seems to hook up so well and win every all motor race there is next year what you think ?


14.1 with a bone stock b16 in a eg hatch with radials is what every b16 hatch ive ever seen runs whats so special about that hell ive seen them run 13.9 bone stock thats not anything special.

[Evil Goat]

SUPER DOOPER FAST....

as if you know anything about fast...

[allmotorcrx]

Im having trouble with fourth gear so i still havnt got a clean pass and i weigh about 500 more pounds than you do but by comparing your eigth mile times there is no way man im making 252 to the wheels now and there is no way. I have heard of some of these miricale motors from japan but if you tear it down i bet somebody built it in japan before you bought it or at very least its a stock type s. If you just bought it then you realy dont know if its stock or not honestly man. Im also 31 been doing this for along time and can drive the shit out of a car hell we can just bet reaction times if you want to im that confident in my driving (not saying you cant drive) just saying if you know as much as you say you do then you yourself know that something doesnt ad up . Thats just my two opion but personaly i think we need to just put my motor in your car since it seems to hook up so well and win every all motor race there is next year what you think ?


14.1 with a bone stock b16 in a eg hatch with radials is what every b16 hatch ive ever seen runs whats so special about that hell ive seen them run 13.9 bone stock thats not anything special.

when we brake it down i will for sure check it out but pretty sure its stock. had a friend with an h22 from same place bone stock took it to cft got it tuned and it hit 204 on the dyno no header or nothing they thought it was built but last week my buddy broke it down to build and everything was stock.all mine has it a tune on it thats all so no way im more than 210whp,but if i hit 11s i will brake it down and see.

[h22 jones]

cool man either way hell of a motor and very nice times.

[atlplayerr]

as if you know anything about fast...

There u go starting shit again....

[h22 jones]

one more question how many times did it run 12.2 and what is your trany code if you dont mine me asking?

[allmotorcrx]

one more question how many times did it run 12.2 and what is your trany code if you dont mine me asking?

I ran back to back 12.3s letting out because I was all over the track and did not know why.then got a full pass in then found out I had a bad axle damn advance axles LOL

[allmotorcrx]

Not sure about tranny code I know it's off a us spec 22

[Mmmm_Bacon]

ill say this, jason can drive the fuck out of the car, and anyone who knows him, know he can do just that. His feet look like a duck in water lol

as for the times, I can also vouch that the motor hasnt been touched in his hands. and if there IS anything done to the motor, then it was done before he purchased the swap, and it was un told.


It can be said in books this or that, Only way i see it to end this debate is for someone else to come to steele, Someone who is a consistent driver at other tracks to come to Steele AL and run their car. if they run 3-5 tenths faster, its the track, if not then its purely the driver, and let it be said and done.

I personally dont think its the track, my car ran a 13.2 the week before on 22's spinning, and i think a 2.1 60ft, which is about right where it should be

[allmotorcrx]

ill say this, jason can drive the fuck out of the car, and anyone who knows him, know he can do just that. His feet look like a duck in water lol

as for the times, I can also vouch that the motor hasnt been touched in his hands. and if there IS anything done to the motor, then it was done before he purchased the swap, and it was un told.


It can be said in books this or that, Only way i see it to end this debate is for someone else to come to steele, Someone who is a consistent driver at other tracks to come to Steele AL and run their car. if they run 3-5 tenths faster, its the track, if not then its purely the driver, and let it be said and done.

I personally dont think its the track, my car ran a 13.2 the week before on 22's spinning, and i think a 2.1 60ft, which is about right where it should be

Thanks man you know me I'm not trying to hide nothing.

[boosted_nonv]

Just wanted to say that my car has never been dynoed and has never run that on drag radials.

and I also have a hard time believing the hp vs weight vs 1/4mi. of allmotorcrx's car.

Funny how allmotorcrx didnt answer u, and u always win the all motor class when u go, the car is just lighter than he think it is thats all

[BABY J]

Funny how allmotorcrx didnt answer u, and u always win the all motor class when u go, the car is just lighter than he think it is thats all

Which gets us RIGHT back to my thoughts : http://www.importatlanta.com/forums/...9&postcount=62

[Evil Goat]

There u go starting shit again....

i can back it up though...

[Vteckidd]

Just wanted to say that my car has never been dynoed and has never run that on drag radials.

and I also have a hard time believing the hp vs weight vs 1/4mi. of allmotorcrx's car.

I know what it makes on the engine dyno as we use the same one. Yours made "less" than my old 2.0l engine, we have the same builder

I heard from Don and someone else you were running 12.1-12.3s on Drag radials, 11s on slicks ive seen in person/video.

Your car is really well setup.

[Vteckidd]

i also heard from a bunch of other people from up there in Rome that Allmotorcrx cut all the sheetmetal out of the rear of the car like all the fender wells and metal re-enforcement.

I think his car is much lighter than he is letting on

[boosted_nonv]

well me and Baby J definitely agree with that

[allmotorcrx]

i also heard from a bunch of other people from up there in Rome that Allmotorcrx cut all the sheetmetal out of the rear of the car like all the fender wells and metal re-enforcement.

I think his car is much lighter than he is letting on

Here we go with he said she said bullshit,Kidd your than fucking welcome to look at my car all I did was gut the inside out hell I still have all the braceing under the dash.I have not cut any metal out whatsoevery,don't know who your source is but I will tell you and them that y'all are stupid as fuck.like I done said I put it on the scale at my work and it weight 1840 without me in it.so get your shit straight before you asume anything

[SmackedInATL]

You guys getting all excited over this lil CRX. At the end of the day it is still a piece of shit with a mediocre motor. I don't understand all the fuss, but then again I'm not a ricer.

/thread

[Evil Goat]

You guys getting all excited over this lil CRX. At the end of the day it is still a piece of shit with a mediocre motor. I don't understand all the fuss, but then again I'm not a ricer.

/thread

fast is fast. it wasn't too long ago you were running 12's...

[NEMO]

You guys getting all excited over this lil CRX. At the end of the day it is still a piece of shit with a mediocre motor. I don't understand all the fuss, but then again I'm not a ricer.

why because its not a mustang?

fast is fast. it wasn't too long ago you were running 12's...

i hope to be fast one day in my honda

[Evil Goat]

i hope to be fast one day in my honda

ain't happening....

[.:Stirfry:.]

no vids no pics. ?

[allmotorcrx]

no vids no pics. ?

Trying to go to Steele sunday your more than welcome to come see in person

[NEMO]

ain't happening....

400 SHOT

[Vteckidd]

Hey man i'm just saying why multiple peole have told me that you took a sawzaw to that bitch lol

I don't really care anymore good luck

[allmotorcrx]

Hey man i'm just saying why multiple peole have told me that you took a sawzaw to that bitch lol

I don't really care anymore good luck

Well they told you wrong

[Vteckidd]

awesome hope you run 10s this weekend

[allmotorcrx]

awesome hope you run 10s this weekend

Na 11s

[Dougk1401]

Damn Jason cant believe Im just now chiming in on this thread but you look like lord of the freaking river dance when you drive!!